THE INDEPENDENT VOICE OF MOTORCYCLE CULTURE

NEWS / RIDES / GEAR / FREEDOM

Gerbing G4 12V Heated Motorcycle Gloves: Power Demand, Warmth and Fit

Motorcycle jacket, helmet, gloves and riding boots laid out on wooden floor

BFP GEAR TEST BENCH / DOCUMENTED PRODUCT PROFILE / NOVEMBER 2026

Cold hands affect comfort and how precisely a rider operates controls. Gerbing’s G4 is a 12V motorcycle glove with wired heating and insulating/protective components intended for extended cold-weather rides. Before buying, the most important questions are electrical connections, weatherproofing terminology and fit on the bars.

Review status: Research only. We have not purchased, ridden with, measured or physically tested this specific product. Descriptions of performance are attributed to the manufacturer; no score or independent verdict is invented.

Heating specifications

Gerbing describes Microwire heating through the glove and into the fingers, 150 grams of Thinsulate and a nominal maximum heating output of around 13 W per glove, drawing approximately 1.1 A each from a 12V power source. For the pair, that represents a notable but usually manageable load whose compatibility still depends on the motorcycle’s available charging capacity.

The company lists a standalone battery harness/Y-harness and controller as separate requirements depending on setup. An advertised temperature figure is not a guarantee that fingers will reach that temperature in wind, rain or different ambient conditions.

What else is built into the glove

The manufacturer cites aniline cowhide, an AQUATEX breathable water-resistant membrane, palm-impact padding, reflective elements, a touchscreen-compatible finger and adjustable wrist closure. Be precise about ‘water resistant’ versus guaranteed waterproof; those are not interchangeable claims.

Buyers should check any available formal protective-equipment certification and whether the product’s palm coverage, stitching and fastening meet their riding needs.

Using it on a cruiser

Wiring must allow full arm and handlebar movement, with no snag on clutch, throttle or steering. Heated gloves connected to a jacket liner may simplify cable routing; separate use requires suitable connection equipment and careful management of cables when dismounting.

Try the gloves with the actual jacket cuff and handlebar controls. Insulation thickness can change fine finger movement; a comfortable pair standing indoors may feel bulky on smaller switchgear.

Editorial conclusion

A credible product to shortlist for riders who regularly face cold autumn roads and want heated gloves connected to a motorcycle’s electrical supply. We cannot claim measured warmth, battery or long-term seam performance without a controlled test.

Pre-purchase checklist

  • Add both gloves’ demand to the motorcycle electrical budget.
  • Confirm which harness and controller are included.
  • Check leather fit and control dexterity.
  • Inspect wrist closure and jacket cuff weather overlap.
  • Read care, wash and warranty instructions.

Manufacturer documents

Gerbing — G4 12V heated glove official specifications

Document review November 2026. Check the latest local product version and included accessories before purchase. Featured photograph: サフィル/Wikimedia Commons, illustrative riding gloves and protective gear; not Gerbing G4; this is illustrative, not the specific product reviewed.


Return to the Newsroom · Send a correction or story tip